Wednesday, October 22, 2008

My Jeep just quit!

Today I was driving along in my Jeep Cherokee and it suddenly lost power. I looked down and saw the tach was reading zero. I bumped the shifter into neutral and after a few tries, it started back up. I was pretty sure I knew what the problem was, but I did not want to mess with it in traffic. It ran fine after that initial failure.

Later that afternoon when I went to star up my Jeep, it started and then immediately died. I first checked the mounting for the ecu and the plug for the CPS. Both seemed fine.

I then moved to the grounding bolt on the back of the block. Sure enough one of the main ground wires had broken loose. I was able to position the wire where it made contact an the other wires held it in place so I could drive home.




I also found one of the other wires was loose in its terminal so I replaced both with new ring terminals.








Bookmarkz

2 Comments:

Anonymous Anonymous said...

Thanks! I learned something.

http://frisbeepainting.com

9:02 PM  
Anonymous Anonymous said...

Where exactly is this located? Im having the same issue. :(

7:12 PM  

Post a Comment

<< Home